Model-level range presence is a source-coverage check. It does not confirm that a repair fits every engine or model year.
Vehicle problem research
Audi SQ5 problems and repair guidance
Read 5 documented issue files for the Audi SQ5, including symptoms, source-defined vehicle scope and the published repair or diagnostic steps. A matching model name does not diagnose your car or confirm VIN eligibility.
This profile contains problem research. Model-specific warranty cost estimates and aggregate NHTSA complaint counts are not included for this model.
Choose the exact year
Audi SQ5 model-year research
Model-year coverage varies. Each page shows the available problem files and identifies whether warranty estimates and federal report counts are included.
Problem research and repair guidance
Audi SQ5: symptoms, affected vehicles and documented fixes
Match the symptom and the exact vehicle scope before arranging work. These files preserve the FixCatalogue research, with the manufacturer position, safe checks and original evidence available here.
5documented issue files
5vehicle systems
4 recall files · 1 other manufacturer file. These are editorial file counts, not distinct campaign totals, failure rates or a complete recall history.
Body & exterior
Safety recall published2018, 2019Loose rear wheel-arch trim
A protruding rear wheel-arch cover or fresh wind noise can signal the loose trim addressed by Audi recall 66K8.
Audi recalled certain 2018 to 2019 SQ5 vehicles because the rear wheel-arch cover trim could loosen and detach while driving. The detached trim could become a road hazard. Recall status is VIN specific even when the model and year match.
Symptoms to compare
- The edge of a rear wheel-arch cover protrudes from the body
- Wind or fluttering noise comes from the rear wheel area
- A wheel-arch trim panel feels visibly displaced
Other ways owners describe it: fender flare coming loose; plastic trim sticking out by rear wheel; wheel arch cover flapping; new wind noise from rear wheel; body trim falling off Audi.
Which vehicles the source covers
- Certain 2018 to 2019 Audi SQ5 vehicles
- Recall 66K8 eligibility must be checked by VIN
Safety recall eligibility is determined by VIN, not by mileage or visible wear alone.
Published recall remedy
Audi's recall remedy is to replace the four clips securing the forward part of the rear wheel-arch trim with revised clips.
Complete recall 66K8Authorized recall repair · Audi estimated about one hour
Check the VIN for recall 66K8. An authorized Audi dealer replaces the four specified retaining clips when the vehicle is included.
Look for a lifted edge while parkedSimple visual check · 3 minutes
With the vehicle parked, visually compare the rear arch covers on both sides and photograph any edge that is standing away from the body.
Limit: Do not pull on the trim or try to secure recall parts with tape for road use.
Evidence for this issue
- NHTSA 19V-737 / Audi 66K8: Rear wheel-arch trim safety recall
NHTSA record · Oct 22, 2019
The recall includes certain 2018 to 2019 SQ5 and 2018 to 2020 Q5 vehicles.
Electrical & software
Official safety recall2018, 2019, 2020, 2021, 2022Campaign 21V947000Electrical or software fault may disable vehicle functions
A liquid spill in the rear seat, or water ingress from an insufficient body seam underneath the vehicle may allow liquid to penetrate the gateway control module, causing it to shutdown.
NHTSA campaign 21V947000 includes certain 2018 to 2022 Audi SQ5 vehicles. Volkswagen Group of America, Inc. (Audi) is recalling certain 2021-2022 Q5 Sportback, SQ5 Sportback, 2018-2022 Q5, and SQ5 vehicles. A gateway control module shutdown will suddenly reduce engine power, increasing the risk of a crash.
Symptoms to compare
- Warning messages, a blank display, a no-start condition or loss of a vehicle function may occur
- An open campaign appears when the complete VIN is checked
- Some recalled vehicles may show no advance warning before the component fails
Other ways owners describe it: dashboard lit up with warnings; car electronics stopped working; screen keeps rebooting; car will not start after update; electrical problem with no warning; software recall.
Which vehicles the source covers
- 2018 to 2022 Audi SQ5
- NHTSA campaign 21V947000
- The manufacturer filing lists 288,991 potentially affected units across the complete campaign.
- VIN eligibility determines whether this recall applies to an individual vehicle
Safety recall eligibility is based on the VIN and campaign scope, not ordinary warranty mileage. Check the complete VIN even when the vehicle is outside its original warranty.
Component in the source: ELECTRICAL SYSTEM:BODY CONTROL MODULE/BCM
Published recall remedy
Dealers will install a protective cover on the gateway control module and seal an underbody seam as necessary, free of charge. Owner notification letters were mailed January 21, 2022. Owners may contact Audi customer service at 1-800-253-2834.
Use the official recall remedyAuthorised dealer · Confirm with VIN
Dealers will install a protective cover on the gateway control module and seal an underbody seam as necessary, free of charge. Owner notification letters were mailed January 21, 2022. Owners may contact Audi customer service at 1-800-253-2834.
Limit: Do not buy parts from the campaign description alone. VIN scope, superseded remedies and parts availability can change.
Check the complete VIN before arranging workBasic check · 5 minutes
Enter the 17-character VIN in NHTSA's recall lookup and ask the manufacturer or an authorised dealer to confirm whether the campaign is open for this vehicle.
Limit: A year, make and model match does not prove that every vehicle is included. The VIN result controls eligibility.
Evidence for this issue
- 21V947000: Official campaign record for Audi SQ5
NHTSA safety recall · Dec 8, 2021
NHTSA campaign data lists the defect, safety consequence and manufacturer remedy. The manufacturer filing lists 288,991 potentially affected units across the complete campaign.
Engine & cooling
Manufacturer diagnostic bulletin2018, 2019, 2020, 2021, 2022, 2023, 2024Coolant loss from the V6 coolant pump
Repeated coolant loss on a V6 SQ5 needs an active-leak check before any pump replacement.
Audi published a diagnostic procedure for coolant loss on 2018 to 2024 SQ5 models with the V6 TFSI engine. It tells technicians to locate the leak precisely and warns that a small trace in the pump drip cup can be normal. A reproducible leak, rather than residue alone, is needed before replacing a component.
Symptoms to compare
- Coolant level falls repeatedly
- Coolant warning lamp appears
- A confirmed wet leak is found at the coolant pump area
- Dried coolant residue may be visible in the engine bay
Other ways owners describe it: SQ5 coolant keeps dropping; pink coolant under Audi; coolant warning comes back; Audi water pump leaking; sweet smell from engine bay; coolant crust near pump.
Which vehicles the source covers
- 2018 to 2024 Audi SQ5
- V6 TFSI engine
- All bulletin criteria and the exact leak location must match
Audi's bulletin is based on vehicle configuration and confirmation of an active leak, not a stated mileage threshold.
Manufacturer position and diagnosis
Audi tells technicians to clean and dry the area before checking the level at idle and higher engine speed. A pressure test and pump vacuum-line check then identify whether a component is faulty.
Confirm the exact leak sourceAudi or cooling-system specialist · Diagnosis before repair
Have the cooling system inspected under Audi's published procedure. It combines a pressure test with a pump vacuum-line check and allows replacement only after the leak source is confirmed.
Limit: Residue in the pump drip cup by itself is not proof that the pump must be replaced.
Log the cold coolant levelBasic observation · 5 minutes
When the engine is completely cold and the vehicle is level, photograph the reservoir level and note any warning date. Repeat without opening a hot system.
Limit: Never open a pressurized or hot cooling system.
Evidence for this issue
- TSB 19-23-39 / 2070349/1: Loss of coolant from coolant pump, V6 TFSI
Manufacturer bulletin · May 17, 2023
The bulletin covers 2018 to 2024 SQ5 models and separates normal trace residue from a confirmed leak.
Safety restraints
Official safety recall2025Campaign 26V266000Seat belt may not restrain an occupant
The driver and front passenger seat belts may have been manufactured incorrectly, and fail to properly restrain occupants during a crash.
NHTSA campaign 26V266000 includes certain 2025 Audi SQ5 vehicles. Volkswagen Group of America, Inc. (Audi) is recalling certain 2025 Q5, Q5 Sportback, SQ5, and SQ5 Sportback vehicles. Improperly restrained occupants have an increased risk of injury during a crash.
Symptoms to compare
- A buckle, retractor or warning system may not work as expected, though a VIN check is still required
- An open campaign appears when the complete VIN is checked
- Some recalled vehicles may show no advance warning before the component fails
Other ways owners describe it: seat belt will not latch; seatbelt keeps coming loose; belt buckle feels loose; seat belt warning stays on; belt will not retract; seat belt recall.
Which vehicles the source covers
- 2025 Audi SQ5
- NHTSA campaign 26V266000
- The manufacturer filing lists 7,425 potentially affected units across the complete campaign.
- VIN eligibility determines whether this recall applies to an individual vehicle
Safety recall eligibility is based on the VIN and campaign scope, not ordinary warranty mileage. Check the complete VIN even when the vehicle is outside its original warranty.
Component in the source: SEAT BELTS:PRETENSIONER
Published recall remedy
Dealers will replace the driver and front passenger seat belts as necessary, free of charge. Owner notification letters were mailed May 29, 2026. Owners may contact Audi's customer service at 1-800-253-2834.
Use the official recall remedyAuthorised dealer · Confirm with VIN
Dealers will replace the driver and front passenger seat belts as necessary, free of charge. Owner notification letters were mailed May 29, 2026. Owners may contact Audi's customer service at 1-800-253-2834.
Limit: Do not buy parts from the campaign description alone. VIN scope, superseded remedies and parts availability can change.
Check the complete VIN before arranging workBasic check · 5 minutes
Enter the 17-character VIN in NHTSA's recall lookup and ask the manufacturer or an authorised dealer to confirm whether the campaign is open for this vehicle.
Limit: A year, make and model match does not prove that every vehicle is included. The VIN result controls eligibility.
Evidence for this issue
- 26V266000: Official campaign record for Audi SQ5
NHTSA safety recall · Apr 24, 2026
NHTSA campaign data lists the defect, safety consequence and manufacturer remedy. The manufacturer filing lists 7,425 potentially affected units across the complete campaign.
Steering & suspension
Official safety recall2015Campaign 15V452000Steering control may be reduced
(Volkswagen) is recalling certain model year 2014-2015 Audi SQ5 vehicles manufactured May 22, 2013, to April 14, 2015.
NHTSA campaign 15V452000 includes certain 2015 Audi SQ5 vehicles. Volkswagen Group of America, Inc. (Volkswagen) is recalling certain model year 2014-2015 Audi SQ5 vehicles manufactured May 22, 2013, to April 14, 2015. If the vehicle experiences a loss of power steering assist, extra steering effort will be required at lower speeds, increasing the risk of a vehicle crash.
Symptoms to compare
- Steering effort, response or control may change, sometimes with a warning message
- An open campaign appears when the complete VIN is checked
- Some recalled vehicles may show no advance warning before the component fails
Other ways owners describe it: steering suddenly feels heavy; power steering stopped working; wheel is hard to turn; steering warning light; car pulls while steering; loss of steering assist.
Which vehicles the source covers
- 2015 Audi SQ5
- NHTSA campaign 15V452000
- The manufacturer filing lists 5,625 potentially affected units across the complete campaign.
- VIN eligibility determines whether this recall applies to an individual vehicle
Safety recall eligibility is based on the VIN and campaign scope, not ordinary warranty mileage. Check the complete VIN even when the vehicle is outside its original warranty.
Component in the source: STEERING:ELECTRIC POWER ASSIST SYSTEM
Published recall remedy
Volkswagen will notify owners, and dealers will update the power steering control module software, free of charge. The recall began on July 31, 2015. Owners may contact Audi customer service at 1-800-253-2834.
Use the official recall remedyAuthorised dealer · Confirm with VIN
Volkswagen will notify owners, and dealers will update the power steering control module software, free of charge. The recall began on July 31, 2015. Owners may contact Audi customer service at 1-800-253-2834.
Limit: Do not buy parts from the campaign description alone. VIN scope, superseded remedies and parts availability can change.
Check the complete VIN before arranging workBasic check · 5 minutes
Enter the 17-character VIN in NHTSA's recall lookup and ask the manufacturer or an authorised dealer to confirm whether the campaign is open for this vehicle.
Limit: A year, make and model match does not prove that every vehicle is included. The VIN result controls eligibility.
Evidence for this issue
- 15V452000: Official campaign record for Audi SQ5
NHTSA safety recall · Jul 20, 2015
NHTSA campaign data lists the defect, safety consequence and manufacturer remedy. The manufacturer filing lists 5,625 potentially affected units across the complete campaign.
Confirm who pays before authorizing work
A recall remedy follows the campaign and VIN eligibility. A service bulletin provides diagnosis or repair instructions; it does not by itself promise payment. Manufacturer warranty extensions and support programs have their own conditions.
Compare recalls, bulletins and warranty extensions →Keep a current problem separate from future coverage
These files do not supply a shop quote. Ask for a diagnosis and written estimate, then check recall remedies or existing coverage. A new vehicle service contract generally excludes pre-existing conditions.
Prepare a useful description for the mechanic →Each file retains its original source review date. Historical remedy wording can change; check the current manufacturer notice and NHTSA VIN lookup for your vehicle. The separately dated NHTSA counts elsewhere on this page use a different dataset and scope.
Read the evidence for this vehicle
What can the data tell you about Audi SQ5?
No model-specific individual-repair price keys are retained for Audi SQ5 in this library. Generic parts and labor estimates, public records and separate annual cost references may still be available.
An unmatched specification is an information gap. Do not borrow an engine or drivetrain from another year.
The manufacturer instruction can describe software, inspection or a smaller component before a complete assembly replacement.
Price-key audit reviewed October 12, 2026; EPA source snapshot 2026-08-07. Individual-repair ranges and annual repair-budget references are different datasets.
Cost-library audit
The evidence behind a repair estimate
In our 44-category library, 24 categories have attached published benchmarks and 20 use planning assumptions. The audit separates the appearance of a precise total from the strength and scope of its inputs.
44 repair categories in our current library; a content audit, not a market survey
See the analysis, charts and method →Manufacturer-path review
The repair path before the replacement price
The 21 selected non-recall files include software, service, diagnosis-dependent and component paths. The procedure attached to a confirmed condition can be more specific than a replacement estimate for the named system.
All 21 non-recall files in the retained collection; manual editorial classification
See the analysis, charts and method →