Engine repair

Engine oil cooler replacement cost

Use the parts prices, labor hours and local totals to plan for this repair. Confidence B applies to a broad repair category; this is not a shop quote for your specific vehicle.

$425-$445parts range
1.6-2.3labor hours
0diagnostic hours modeled
per repairprice basis
Animated automotive components representing engine oil cooler replacement

Cost and coverage

How this repair affects warranty value

Engine oil cooler replacement carries a parts spread of $20 between our low and high benchmarks. At the $148 median metro rate, midpoint labor and diagnosis add about $295 before tax or shop supplies.

Our general coverage guide marks this repair as often covered by exclusionary plans, subject to the cause of failure and contract exclusions. Preauthorization and the documented cause of failure still control reimbursement.

See all engine repairs

Local estimates

Estimated total repair bills by city

These examples combine the same parts benchmark with modeled independent-shop labor rates in four metros.

MetroLabor midpointTotal estimate
Dallas, TX$144/hr$623-$823
New York, NY$160/hr$645-$864
Los Angeles, CA$165/hr$652-$876
Miami, FL$144/hr$624-$823

Estimate notes

Oil-line, seal and coolant contamination work may be added after diagnosis.

National benchmark: $661-$791, with $425-$445 in parts and $236-$346 in labor. Source: RepairPal, updated 2026-06-18. Local totals normalize the published labor range to this site's metro labor model.

Before authorizing a repair

What to check before paying for engine oil cooler replacement

Check what the repair price includes

The benchmark price is for per repair. Parts run from $425 to $445; the modeled repair takes 1.6 to 2.3 labor hours, with 0 diagnostic hours in the midpoint calculation.

Oil-line, seal and coolant contamination work may be added after diagnosis. Ask the shop to identify which of those items are included before comparing two totals.

Compare the estimate with a shop quote

This repair totals about $731 using a $148 hourly rate from the middle metro in our labor model. We calculate that amount from our assumptions; it is not an observed average bill for your exact car.

This repair category uses a published RepairPal benchmark. Your engine, how hard the part is to reach and the choice of replacement part can still put a quote outside that range.

Check the cause as well as the component

A contract can list engine coverage and still exclude the cause of this failure. Ask the administrator about diagnosis, labor-rate limits, connected damage and preauthorization before the shop starts work.

Factory coverage and an open safety recall are separate checks. Use NHTSA's VIN recall lookup to check the individual vehicle; a model-level recall count cannot tell you whether your car is affected.

Ask for these details in writing

  • The diagnosed condition, the part number and the number of assemblies being replaced.
  • Parts type, labor hours or flat-rate charge, diagnosis, fluids, calibration and taxes as separate lines where applicable.
  • What you owe if the repair is declined or a contract claim is denied.
  • The repair warranty and the amount that requires your approval before extra work begins.

The FTC's repair guide recommends a written estimate identifying the condition, parts and labor. Its service-contract guidance explains why authorization, exclusions and reimbursement limits matter.

Need to describe a symptom before a diagnosis? Choose the exact vehicle in FixCatalogue and open the underlying source. A symptom match alone does not justify replacing this part.